A broken garage door cable can be a hassle, especially if you have a car parked in the garage. But before you call a repairman, here's a step-by-step guide on how to fix your garage door cable yourself. With the right tools and a little bit of patience, you can save yourself time and money by doing it yourself.
Step 1 – Gather the Tools You Need
Before you start any garage door cable repair job, make sure you have all the necessary tools. For this job, you'll need pliers, locking pliers, an adjustable wrench, cable cutters, and a ladder. Make sure that all your tools are clean and in good condition before starting the garage door cables repair.
Step 2 – Disconnect Power and Unhook the Cables
Before doing anything else, make sure that your power is disconnected from your garage door opener system. Then locate the cables attached to your garage door springs and carefully unhook them using your pliers or locking pliers. Be careful not to damage any of the other parts while unhooking the cables.
Step 3 – Remove Old Cable & Replace it with New Cable
Once you have disconnected all of the cables from your garage door springs, use your cable cutters to remove the old cable from its bracket or pulley system. Now take out the new cable that came with your garage door cables repair kit (or buy one separately) and thread it through all of the necessary pulleys until it is securely fastened at each end. Make sure that each connection is tight so that there is no slack in any part of the new cable once it is properly installed.
Step 4 – Reattach Cables & Reinstate Power Source
Reattach all of your cables to their respective brackets or pulleys using either pliers or locking pliers depending on what type of bracket system you have in place for each connection point. Once everything is securely fastened, reinstate power back into your garage door opener system so that it will be ready for use when needed.
Step - 5 - Test the Cables
Once all of your cables are properly installed, it's time to test them out. Open and close your garage door slowly at first, paying attention to how smoothly it operates. If you notice any issues with how the garage door is operating, then go back and check each cable connection point for tightness so that everything remains secured in place.
Step -6 - Maintain Your Garage Door
To keep your garage door operating properly, it is important to regularly inspect and maintain all its components. Make sure to check the cables every few months or so for any signs of wear and tear. If you notice something wrong, make sure to address the issue right away before it becomes a bigger problem.
Step - 7 - Call a Professional
If you have gone through all the steps above and your garage door still isn't operating properly, it may be best to call in a professional repairman. They can help identify any underlying issues that may be causing the problem, as well as assist with any additional repairs. It's always better to err on the side of caution when it comes to garage door cable repairs so that your safety and the integrity of your home remain intact.
Conclusion:
With just a few simple steps outlined above, you can easily repair any broken cables on your own without having to hire an expensive technician or purchase extra parts along with their installation fees! With this step-by-step guide as well as some basic hand tools, anyone can safely fix their garage door cables without breaking a sweat! So don't wait any longer - take control of this project today and show off those handyman skills!
